EXUP Worldwide

Welcome Ck, I thought you would have finished that tail by now
I remember you from the "old" site!
Regards
Ozzyfzr

The particular immobilizer on this bike was designed to cut the crank trigger input to the ignition module if not dis-armed. Also if the device is not switched off and the bike moved, it will flash the indicators and sound the alarm, the way this was playing up, it was causing a power drain and not ...

Bike fixed for Eli, away on business in Townsville so I had the opportunity to drop in! Turned out to be incorrectly wired relay, faulty start button and immobilizer issues. Removed immobilizer, re-wired relay, fixed starter button and away you go!!!!! Nice to meet a fellow FZR owner with issues and...

You have an Email Eli
Regards
Ozzyfzr

By the looks of the setup you have, the swinger is offset to the left by approx 20mm (wheel centreline different to front). Just thinking out loud, why didn't you make an offset sprocket carrier to go on the hub and placed swinger in centre???? then fabricated a new wider chain slider block (wear pa...

Were the extinguishers filled with petrol???? def seemed to make it worse!!

I would like to see A.West do well, and waiting to see how J.Lorenzo will go!

I hope that Yamaha have made up some ground in Winter Development and testing, as long as we see good racing and no bad accidents it's gotta be good!!!

As suggested before and found on a car I used to work on, the main "huge" cabling was shorted to the block on a tight section of wiring. Only when you tried to crank all power sucked straight to earth!!! I would suggest disconnecting everything from the +ve terminal and run 1 large wire (as big as t...

Welcome 2dogs, enjoy the site

$$$$$$$$$$$$ can replace plastic, not so sure on flesh tho!
Glad your OK!!

kiwi60 wrote: 'don't step out of line'

Do they have no spines! or just deep pockets????

Life and Limb, get what you expect to get!!! a tyre that works!

Seen this before with "dual composite" tyres, soft sidewall harder centres. It's the intersection point of the 2 compounds!!!

My front a Michelin used to have it - threw it on the heap!!!!!!

Now, I understand fluid and air dynamics but, from what I was told, after the fact which I did, you are not supposed to knife edge the area between the valves. Why? Yes, aircraft wings have a rounded leading edge and a sharp trailing edge. But, I believe that since I am not tying to "fly" though th...

Corporate "GREED"!!!!!!! nuff said!

Oil fuel contaminated, it's bound to be with a stuffed petcock and left standing, it would've leaked past a needle seat, dripped down an inlet throat and sat on top of the piston and then leaked down to the sump. I would refresh the oil and filter, repair the petcock and the usual maint items like p...

Valve clearances set wrong!!!!!!!!!!!!!!!!!!!!!!!!!!

Check them first, all manner of issues especially when it gets warm!
Blow back into air-box from partially open valve will cause your problem.

Regards
Ozzyfzr

Glad to hear that all went well, and I hope the tribute to Wayne gets the turn-out, I'm sure the guys and gals will come out in Waynes memory.

Be strong for yourself and the little-ones, I will be thinking of you.

Regards
Pete

My thoughts will be with you on Friday

Regards
Pete

Colette, say what you feel for us all to read, it will help you heal. I hated every living soul when my father died and the only way I dealt with it was to talk and vent-off, you have to do this and I for one will be here to listen!

Regards
Pete

All I can say is look after yourself, and take care of your little angels. I never met sandman77 but felt I knew him. My thoughts are with you and your immediate family.

You are in my prayers

Love from Pete, AKA Ozzyfzr