EXUP Worldwide

Jim,<br><br>Thanks for looking up bikebandit.com for their part numbers. I too had been looking at part numbers (parts.yamaha-motor.com) trying to verify if the valve pads across FZRs are the same.<br><br>'87 and '88 FZR750s and FZR1000s have valve pad numbers starting with 1AA-12168-xx-xx.<br><br>'...

I'm out of luck... there are no local suppliers here in Manila that have valve pads.<br><br>Can someone please confirm if the valve adjusting pads used on '87-'88 FZR750/1000 is the same as the one used on '89-later FZR1000s? How about on FZR600s?<br> <p><br>Jobo<br>1987 FZR750<br>(Jap spec)<br>Phil...

Hello Guys,<br><br>I finally got to open my valve head yesterday after I got a used timing rotor from a Yamaha XJ from local Yamaha distributor here in Manila sometime last week.<br><br>Unfortunately, a little more than 50% of the intake valves on my bike had clearances less than 0.11mm (I measured ...

Hello Jim,<br><br>Yes, I do plan to cut my feeler gauges just like you said... That is why I was asking for the width that would fit...<br><br>I'd like to ready with the feeler gauges before I open the head.<br><br>Thanks.<br><br>- Jobo<br> <p></p><i></i>

Hello,<br><br>I am looking at checking the valve clearances on my 1987 fzr750 this coming weekend.<br><br>I haven't seen the insides of the cylinder head yet so i would like to ask guys here who have had more experience with their 20-valve mills...<br><br>What should be the width of the feeler gauge...