Clarke Nibbler
Posted: Sun Apr 05, 2020 5:42 am
Dave just did a site check in.
Dunno mate, but anything that attaches to a drill I would be dubious about.
What are you wanting to do?
EXUP Worldwide
EXUP Worldwide was born from the ashes of the original EXUP Brotherhood – the definitive forum for all those who have interest in Yamaha FZ, FZR, and YZF motorcycles.
http://exupworldwide.com/forum/
Clarke Nibbler
Page 1 of 1
Re: Clarke Nibbler
Posted: Mon Apr 06, 2020 6:21 am
Re: Clarke Nibbler
Posted: Mon Apr 06, 2020 6:58 am
I was just looking for a simple way of cutting/shaping some ally plate (2mm thick)
Dave
Dave
Re: Clarke Nibbler
Posted: Mon Apr 06, 2020 8:12 am
Buy a jig saw. Drill a hole where you want cuts to intersect.
Years ago I mounted a jigsaw underneath a piece of melanin... it was sort of a band saw without the band!
Just choose the appropriate blade for the material you wish to cut.
For aluminium too fine will clog, too course and you will have a rodeo on your hands!
If you choose to use a jigsaw, put gaffer tape on the feet so you don't scratch up the alloy.
Years ago I mounted a jigsaw underneath a piece of melanin... it was sort of a band saw without the band!
Just choose the appropriate blade for the material you wish to cut.
For aluminium too fine will clog, too course and you will have a rodeo on your hands!
If you choose to use a jigsaw, put gaffer tape on the feet so you don't scratch up the alloy.