Page 1 of 1
clutch switch removal
Posted: Tue Nov 16, 2004 7:26 am
by Hooligan
hi guys,<br><br>anyone know off hand if i will run into any problems removing the small switch under the clutch master cylinder? it is part of the bike's starting safety system, but i'm not sure if disconnecting it will cause the bike to not start at all.<br><br>my service manual doesn't say much on the subject...<br><br>thanks! <p></p><i></i>
Re: clutch switch removal
Posted: Tue Nov 16, 2004 6:13 pm
by cvhjkdis
Hi Hooli-mod, Looks to me like that switch cuts the starter with the bike in gear, clutch out, <!--EZCODE ITALIC START--><em>and</em><!--EZCODE ITALIC END--> a start request input. It's wired roughly in series with the neutral switch. How sure are you, that (that) will never happen? I'd keep it. <p> <span style="font-family:helvetica; color:blue;font-size:xx-small;">Straight up Geek</span></p><i>Edited by: <A HREF=
http://p072.ezboard.com/bexupbrotherhoo ... vhjkdis</A> at: 11/16/04 4:23 pm<br></i>
Re: clutch switch removal
Posted: Wed Nov 17, 2004 3:16 pm
by orionburn
Mine is unhooked at the moment. It starts fine, <!--EZCODE ITALIC START--><em>BUT</em><!--EZCODE ITALIC END--> it won't start unless it is in neutral. That's the only problem I've had. It's a pain sometimes if the bike stalls, but other than that nothing major. <p><!--EZCODE FONT START--><span style="color:navy;">Nate - 87 FZR1000</span><!--EZCODE FONT END--><br><br>Have <!--EZCODE ITALIC START--><em>you</em><!--EZCODE ITALIC END--> seen my fairing?</p><i></i>