Project YZF 1040 injection

The say a picture is worth a thousand words. Take a look at what the other EXUP Worldwide members ride, or post your own pride & joy. Please use your submission point, or post your own link.
New Poster
Posts: 25
Joined: Sun Jul 09, 2006 5:15 am
Location: Netherlands

Post by gertjan1978 » Tue Oct 04, 2011 3:19 pm

The rear wheel is a Galespeed for an YZF R1 1998
You need too make spacers for line out the wheels.
And the front sprocket must go too the left for exact chaine line

The front wheel is a Galespeed for an XJR1200
The wheel must bee machined for the brake disks surfase I believe 1 mm .
The bearing hole must be machined also >front axle is bigger.

But I think the km or mile mechansme will fit.
With my setup it wasnt possible there is not much room wich the ohlins setup.

Greets Gertjan
Hello I'm new on this site. There is a lot of information on this site so, Thanks
Greats Gertjan

Veteran Poster
Posts: 225
Joined: Mon Jun 18, 2007 3:35 pm
Location: Sharpsburgh GA

Post by RocknFZR1000 » Fri Oct 28, 2011 7:58 am

SWEET Ride...! :shock

My other toys:

If you think about it, It's Already To
Late!!! "FZR1000 in Your Face"


Post Reply