Page 2 of 2

Posted: Tue Oct 04, 2011 3:19 pm
by gertjan1978
The rear wheel is a Galespeed for an YZF R1 1998
You need too make spacers for line out the wheels.
And the front sprocket must go too the left for exact chaine line

The front wheel is a Galespeed for an XJR1200
The wheel must bee machined for the brake disks surfase I believe 1 mm .
The bearing hole must be machined also >front axle is bigger.

But I think the km or mile mechansme will fit.
With my setup it wasnt possible there is not much room wich the ohlins setup.

Greets Gertjan

Posted: Fri Oct 28, 2011 7:58 am
by RocknFZR1000
SWEET Ride...! :shock