Page 1 of 1
fz 700
Posted: Sun Oct 05, 2003 8:59 pm
by lightning911
i was just wanting to know if anyone knows if you have to remove the engine to replace the seal behind the front sprocket or if it can be replaced without removing any help will be greatly welcomed ,i just got this bike and the seal started leaking and would really like to get it fixed thank you <p></p><i></i>
Re: fz 700
Posted: Mon Oct 06, 2003 5:45 am
by flyingcircus68
It comes out pretty easy. Just take the sprocket off and it's readily accessible. Punch a couple of holes in its face with an awl biased toward its outer diameter. Thread a couple of sheet metal screws into it only far enough to grab it and yank on them to get it out. Be careful because you only have .200 space between it and the output bearing. One thing to make sure is that it has the slim o-ring sealing the sleave on the shaft. If not, that could be your source of leaking. <p></p><i></i>
Re: fz 700
Posted: Mon Oct 06, 2003 3:53 pm
by lightning911
thank you for your help i will try that <p></p><i></i>