EXUP Worldwide

Posted: **Mon Feb 27, 2006 11:31 am**

Just did Darcy's 92
remove the top cap. Do not remove the spring
use an impact driver to remove the bottom bolt th\at attaches the damper rod. remove spring, as an assembly
pull the dust cover, seal clip and seal...seperate the upper and lower, reverse to assemble. I did one in 10 minuites

Posted: **Mon Feb 27, 2006 12:07 pm**

Don't see no picys.....

Posted: **Mon Feb 27, 2006 12:14 pm**

that's because I couldn't find the freekin camera
Had to go to Costco yestidy afternoon to fetch another one. 6 megapixels insteas of that lowly 3.2 junk

Posted: **Mon Mar 06, 2006 6:30 am**

Would this work on a 93 or 4 750? (UK upside-downers without damping adjustment.)

Posted: **Mon Mar 06, 2006 8:20 am**

Posted: **Sun Mar 12, 2006 7:54 am**

I did my ones the hard way

Your way sounds a whole lot easier than taking the springs out :cool

Mark

EXUP Worldwide

USD Fork seal replacement

USD Fork seal replacement