Tranny Woahs...

dragracer1951 · Post by **dragracer1951** » Sun Sep 09, 2007 10:16 am

It's to slow down the gas flow rates and get the pressure up just in front of the valve face. Aids in cylinder filling.

silver · Post by **silver** » Sun Sep 09, 2007 1:25 pm

Noidly1 wrote:
silver wrote:
Noidly1 wrote: Thanks for the back-up Dude.

Silver; Arogance gets people no-where, Dick...

Would you mind drawing me a picture as I seem to be missing something here ?
You gotta ask?

Evidently.

Post by **FZRDude** » Sun Sep 09, 2007 1:26 pm

ummmm.....

silver · Post by **silver** » Sun Sep 09, 2007 1:52 pm

FZRDude wrote:ummmm.....

No worries. I think there was a misunderstanding somewhere.

Regards,

Arrogant Dick

haunter · Post by **haunter** » Mon Sep 10, 2007 2:18 pm

silver wrote:
FZRDude wrote:ummmm.....
No worries. I think there was a misunderstanding somewhere.

Regards,

Arrogant Dick

(admin edit )Richard.

Noidly1 · Post by **Noidly1** » Mon Sep 10, 2007 4:26 pm

silver wrote:
dragracer1951 wrote:http://www.robinsonindustriesinc.com/

This ought to get ya there...
Do they fall in the category of "If you gotta ask, ....." ? !!

After reviewing the question, there are two ways that it can be taken.

1; "They" meaning me, Do "I" fall in the category of "If you gotta ask?
Then I'm an idiot because i have to ask.

2; "They" meaning Robinson, Do they fall in the category of "If you gotta ask?
Then they are the ones to ask if I/we have a question.

If by 1, statement stands.

If by 2, My bad... Most Apologies. Sorry.

Post by **FZRDude** » Mon Sep 10, 2007 5:10 pm

Personally, I took it as.... "If you have to ask them how much does it cost to have them do the work......then you may not be able to afford it....." type statement.

But hey that's just me and I found the whole thing to be funny..... hence the "Richard" statement/edit (yeah... that was me)

silver · Post by **silver** » Mon Sep 10, 2007 5:13 pm

FZRDude wrote:Personally, I took it as.... "If you have to ask them how much does it cost to have them do the work......then you may not be able to afford it....." type statement.

But hey that's just me and I found the whole thing to be funny..... hence the "Richard" statement/edit (yeah... that was me)

Exactly ! I remember when I built my first "real" engine. Chevy 350 street motor that had no problem running 12's at Atco. Cost me 2K in parts and 2K in machine work and that was in 1984 !